Team H&H
Rc Baja Race Team
Figure 2 Alternate design 1
Figure 1 initial design
Figure 3 alternate design 2
Introduction
The ASME RC Baja event is annual event hosted by Central Washington University’s ASME club in which engineering students compete to design, build and test designs. Students must abide by the rules and regulation set forth by the competition. The Cars must compete in three sperate events designed to test the cars acceleration, handling, and off-road capabilities. The project is to design and build a car that will compete this competition, this report will focus on the drivetrain for the H&H team’s car. The drive train will cover power and delivery, steering, and electronics per the competition regulations and mechanical power delivery.
Project proposal presentation
Link to the most current engineering report
Working device presentation
Final testing presentation
Results
Results​
-
The assembly testing went very and produced times much lower then set by the design requirements, overall, the design for manufacturability was accomplished. ​
-
The top speed testing fell very short of the intended top requirements set forth collectively by the team at an average of 5.27 mph.​
-
The incline testing produced results that were expected, but also met the requirements.
